An in vitro investigation to compare the surface roughness of auto glazed, reglazed and chair side polished surfaces of Ivoclar and Vita feldspathic porcelain

Abstract

The change in surface roughness after different surface finishing techniques has attracted the attention of several prosthodontists regarding wear of opposing teeth or restorative material and the strength; plaque retention and appearance of the restoration. However, there is considerable controversy concerning the best methods to achieve the smoothest and strongest porcelain restorations after chair side clinical adjustments. The purpose of this in vitro study was to compare the average surface roughness of a self-glazed surface, a chair side polished surface and a reglazed surface of ceramic. Two feldspathic porcelain, namely VITA VMK94 (Vita Zahnfabrik, Bad Sachingen, Germany) and IVOCLAR CLASSIC (Vivadent AG, FL-9494 Schaan, Liechtenstein) were selected to fabricate 20 specimens of each in the shape of shade guide tabs. A medium-grit diamond rotary cutting instrument was used to remove the glaze layer, and then the surface of half the specimens were re-glazed and the other half were polished using a well-defined sequence of polishing comprising of: Shofu porcelain polishing system, White gloss disc/polishing wheel, Silicone cone with diamond polishing paste and finally with small buff wheel with pumice slurry. The surface roughness (Ra) (μm) of the specimens was evaluated using a profilometer and scanning electron microscope. The data were statistically analyzed by using Student's t test. The results had shown that there is no statistically significant difference both quantitatively and qualitatively, between the surface roughness of reglazed and chair-side polished surface. In addition, both reglazed and chair-side polished surfaces are better than the autoglazed surface. Within all the groups, there is no significant difference between companies. Polishing an adjusted porcelain surface with the suggested sequence of polishing will lead to a finish similar to a re-glazed surface. Therefore chair-side polishing can be a good alternative to reglazing for finishing adjusted porcelain surface.