Effect of acidic pH on surface roughness of esthetic dental materials

Abstract

Statement of problemExposure to gastric acid in patients with bulimia nervosa and gastroesophageal reflux disease (GERD) causes demineralization of hard tooth structures. This chemical attack also causes the degradation of dental ceramics, which results in increased surface roughness and reduced strength. However, studies comparing the effect of acidic pH on resin matrix ceramic with other computer-aided design and computer-aided manufacturing (CAD-CAM) esthetic materials are lacking. PurposeThe purpose of this in vitro study was to compare the surface roughness changes of different CAD-CAM restorative dental materials after exposure to acidic pH by using a 3D optical interferometer. Material and methodsFive esthetic CAD-CAM block materials, a leucite glass-ceramic (IPS Empress CAD), a zirconia (BruxZir Solid Zirconia), a resin matrix ceramic (VITA Enamic), a lithium disilicate glass-ceramic (IPS e.max CAD), and a feldspathic porcelain (VITABLOCS Mark II CAD) were tested. Eighteen specimens were sectioned from CAD-CAM blocks into 2-mm-thick rectangular plates and immersed in 10 mL of 5% hydrochloric acid (HCl) with (pH=2) at 37 °C for 45 and 91 hours. The surface roughness average (Ra) of the specimens was measured by using a 3D optical interferometer before the storage period (baseline), after 45 hours, and after 91 hours of exposure to HCl. Statistical analyses were performed with the Kruskal-Wallis test and the post hoc Dunn test with Bonferroni correction (α=.05). ResultsRegarding the comparison of surface roughness changes at different periods of evaluation (baseline, 45 hours, 91 hours), there were no statistically significant differences for lithium disilicate (P=.063) or zirconia (P=.513). Leucite glass-ceramic, feldspathic porcelain, and the resin matrix ceramic demonstrated statistically significant differences (P<.001). For all tests that were statistically significant, greater surface roughness was found at the time point with the longer HCl exposure. Regarding the comparison of materials in terms of change in surface roughness between baseline to 45 hours and baseline to 91 hours, the Kruskal-Wallis test indicated a statistically significant difference among the materials in both cases (P<.001). Lithium disilicate and zirconia exhibited the least change in surface roughness among the 5 materials. ConclusionsLeucite glass-ceramic, feldspathic porcelain, and resin matrix ceramic showed statistically significant increases in surface roughness when they were exposed to simulated gastric acid for 45 and 91 hours. Lithium disilicate and zirconia showed no statistically significant change in surface roughness after exposure to HCl for 45 and 91 hours.