Abstract
An improved heating and evaporation model of fuel droplets is implemented into the commercial Computational Fluid Dynamics (CFD) software CONVERGE for the simulation of sprays. The analytical solutions to the heat conduction and species diffusion equations in the liquid phase for each time step are coded via user-defined functions (UDF) into the software. The customized version of CONVERGE is validated against measurements for a single droplet of n-heptane and n-decane mixture. It is shown that the new heating and evaporation model better agrees with the experimental data than those predicted by the built-in heating and evaporation model, which does not consider the effects of temperature gradient and assumes infinitely fast species diffusion inside droplets. The simulation of a hollow-cone spray of primary reference fuel (PRF65) is performed and validated against experimental data taken from the literature. Finally, the newly implemented model is tested by running full-cycle engine simulations, representing partially premixed compression ignition (PPCI) using PRF65 as the fuel. These simulations are successfully performed for two start of injection timings, 20 and 25 crank angle (CA) before top-dead-centre (BTDC). The results show good agreement with experimental data where the effect of heating and evaporation of droplets on combustion phasing is investigated. The results highlight the importance of the accurate modelling of physical processes during droplet heating and evaporation for the prediction of the PPCI engine performance.
Highlights
The geometry geometry of of the the computational computational domain domain was was that that of of aa real real engine engine with with the the base base grid chosen as mm with fixed embedding at the nozzle exit and dynamic grid chosen as 4 mm with fixed adaptive mesh refinement (AMR) embedding at the nozzle exit and dynamic AMR
This agrees with our findings presented in [12] and highlights how important the new model is in the simulation of combustion processes in partially premixed compression ignition (PPCI) engines
A new heating and evaporation model based on the analytical solutions to transient
Summary
In three-dimensional engine simulations, an earlier effort to implement the ETC model into KIVA CFD code was made by Abdelghaffar et al [14] They investigated the effects of heating and evaporation (using the DMC model) on the predicted amounts of fuel vapour and in-cylinder pressure in a diesel engine. This implementation was important for single component fuels but lacked the inclusion of the effects of liquid species diffusion in the case of multicomponent fuels. The ETC/ED models form an important part of the DMC model, in which each component is accounted for without approximation These studies motivated the work on this paper to perform a similar analysis for a wider range of fuels and for a full combustion cycle. The new software has been successfully used for performing engine simulations, with an emphasis on the accurate analysis of fuel sprays under PPCI engine conditions
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
