Abstract
In this study, the material removal rate values, obtained using machining abrasive water jet (AWJM), were modelled using fuzzy logic. The input variables considered are pressure, abrasive flow rate, orifice diameter, focusing tube diameter and standoff distance while the output variable was material removal rate (MRR). Fuzzy logic was developed using Matlab 2013.The mean absolute percentage errors (MAPE) of the predicted values was employed to compare the results with the previously published results obtained using response surface method technique. . The results showed that the predictive model using fuzzy logic model has reduced the errors by 0.28%, which means, using fuzzy logic model to predict material removal rate is sufficiently accurate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
