Abstract
Increasing the flame retardancy of lignocellulosic materials such as Miscanthus × giganteus can effectively enable their wide use. This study examines the fireproofing process of Miscanthus particles using an eco-friendly process by grafting phytic acid and urea in aqueous solution. Miscanthus particles underwent a steam explosion step before being grafted. Fireproof binderless particle panels were manufactured from miscanthus particles with or without adding olive pomace by hot-pressing. The effect of the steam explosion and/or the flame-retardant treatment on the morphology, chemical composition and thermal stability of the particles, as well as the thermal stability of the panels, was investigated. The results showed that water impregnation followed by a steam explosion at 210 °C for 8 min resulted in particles that were rich in lignin and more homogeneous in size (length and width). Fireproof particles were produced with relatively low P and N contents. The flame retardancy of the binderless particle panels was significantly improved when using miscanthus particles treated with phytic acid and urea, as shown by a reduced heat release (HRR) and an increased time-to-ignition. However, the presence of olive pomace significantly decreased the flame retardancy of the panels. Binderless particle panels prepared from grafted miscanthus particles showed the best fire properties and are considered fireproof.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call