Abstract
Cold heavy oil production with sand (CHOPS) has been applied successfully in many oil fields in Canada. However, typically only 5–15% of the original oil in place (OOIP) is recovered during cold production. Therefore, effective follow-up techniques are of great importance. Cyclic solvent injection (CSI), as a post-CHOPS process, has greater potential than continuous solvent injection to enhance heavy oil recovery. Continuous solvent injection results in early breakthrough due to the existence of wormholes; while in CSI process, the existence of wormholes can increase the contact area of solvent and heavy oil and the wormholes also provide channels that allow diluted oil to flow back to the wellbore. In this study, the effects of wormhole and sandpack model properties on the performance of the CSI process are experimentally investigated using three different cylindrical sandpack models. The length and diameter of the base model are 30.48 cm and 3.81 cm, respectively. The other two models, one with a larger length (i.e., 60.96 cm) and the other with a larger diameter (i.e., 15.24 cm), are used for up-scaling study in the directions parallel and perpendicular to the wormhole, respectively. The porosity and permeability of these models are about 35% and 5.5 Darcy typically. A typical western Canadian oil sample with a viscosity of 4330 mPa·s at 15 °C is used. And pure propane is selected as the solvent. The experimental results suggest that the existence of wormhole can significantly increase the oil production rate. The larger the wormhole coverage is, the better the CSI performance obtained. In terms of the effect of wormhole's location, a reservoir or well with wormholes developed at bottom is more favorable for post-CHOPS CSI process due to the gravity effect. The production of the CSI process can be divided into two phases: early time chamber rising and late time chamber spreading phases. The oil recovery factor in the chamber rising phase is almost independent of the sandpack model diameter; and the oil relative production rates (the oil production rate divided by the OOIP) in two models with different diameters are close during the chamber spreading phase due to similar solvent dispersion rate. It is also found that if the wormhole length is the same, the sandpack model length hardly affects the oil production rate in the earlier stage. In terms of the effects of the wormhole orientation, the well with a horizontal wormhole is inclined to get a good CSI performance. Through analyzing the experimental data, a relationship of oil production rate to drainage height is also obtained and verified.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.