Abstract
In the present study, a heat recovery steam generator (HRSG) with a typical geometry and a number of pressure levels used at combined cycle power plants (CCPPs) is modeled. In order to validate the model results, they are compared with data obtained from the actual running power plant located near the Caspian Sea in Iran. The results show a good agreement between the model results and the experimental data. Upon a comprehensive exergy analysis conducted for this HRSG, the results show that an increase in the high and low drum pressures results in an increase in the HRSG exergy efficiency, while an increase in the pinch temperature leads to a decrease in the HRSG exergy efficiency. Also, a fast and elitist non-dominated sorting genetic algorithm (NSGA-II) with continuous and discrete variables is applied to obtain maximum exergy efficiency with minimum total annual cost per produced steam exergy as a two objective functions. The decision variables (or design parameters) are high and low drum pressures, steam mass flow rates, pinch point temperature differences, and the duct burner fuel consumption flow rate. The first objective function included capital or investment cost and operational cost and is minimized while satisfying a group of constraints, and HRSG exergy efficiency is maximized simultaneously. In addition, a regression analysis for curve fitting is conducted to correlate the data to determine the optimal points from the multi-objective optimization to predict the trend of each objective function. The results show that an increase in high pressure and low pressure drum pressure results in increasing HRSG exergy efficiency and also a smaller pinch temperature corresponding to a larger heat transfer surface area and more costly system, as well as higher exergy efficiency and lower operating cost.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call