An electro-Fenton process to treat waste liquor of a hyperaccumulator that contains potentially toxic elements and the COD

Abstract

Rapid and safe treatment of harvested fresh biomass of hyperaccumulators is essential for phytoremediation of metal-contaminated soils. Here, an electro-Fenton (EF) process was used to remove cadmium (Cd) and chemical oxidation demand (COD) from waste liquor from the dewatering of biomass of the hyperaccumulator Sedum plumbizincicola after flocculation precipitation. The results showed that the order of impact of the factors on the removal rate of COD and Cd was pH > electrical current density > H2O2 dosage. Increasing pH promoted Cd removal but hindered COD removal. As current density and H2O2 dosage increased the removal rates of both Cd and COD initially increased and then decreased. Compared to an electrocoagulation process, the addition of H2O2 in EF process greatly enhanced Cd and zinc (Zn) removal. Speciation analysis showed that most of the Cd and Zn in the initial liquor were organically and inorganically complexed. At optimal conditions, e.g., pH 5, current density 15 mA cm−2 and H2O2 dosage 9 g L−1, the removal efficiencies of Cd, Zn and COD reached 99.4, 99.9 and 55.5% after 80 min of EF treatment. Electro-Fenton process can therefore be used to quickly remove trace metals from the waste liquor of the hyperaccumulator.