An Application of Multivariate Simulation in the Cement Industry

Abstract

The profitability of a cement plant depends largely on its capacity to produce homogeneous cement with chemical composition close to specified targets for the cement type produced. One crucial step is the mixing of limestone with other raw materials in proportions calculated to meet these targets. Major design and operation decisions depend on the efficiency of this homogenizing step. The adequate modeling of the mixing process requires simulation of representative cross-correlated time series of chemical compositions of the raw materials involved. The chemical composition signals are obtained by multivariate geostatistical simulation using an LU (Cholesky) decomposition of the covariance matrix. Modifications to the usual LU method are presented. First, the effect on the raw covariance matrix of the closure property of chemical analysis is imposed. Second, the problem of memory space limitations in the LU method is tackled by using overlapping sliding neighbourhoods. The simulation algorithm is applied to the Joppa cement plant owned by Lafarge North America. The simulated raw material input streams are fed into the quality mix control (QMC), a proprietary software that models and controls the mixing operation to produce an output stream with cement characteristics as close as possible to desired targets. Two signal series are studied, one autocorrelated with a moderate temporal range and one with no autocorrelation. The QMC produces C3S output signals having comparable short scale periodic variograms except that the variance of the uncorrelated signal is four times greater than those of the autocorrelated signal and the real Joppa data. The raw material feeder variograms have the same sill for both the white noise and the autocorrelated signals. However, the autocorrelated signal feeder variogram presents lower short term dispersion variance, a characteristic feature of Joppa operations. Our results show the importance of simulating the right temporal structure of the raw materials to realistically forecast the behavior of the output signals. We also discuss some practical implications of these findings for the design and operation of a cement plant.