Abstract
The effect of hydrogen dilution on the optical, transport, and structural properties of amorphous and microcrystalline silicon thin films deposited by hot-wire (HW) chemical vapor deposition and radio-frequency (rf) plasma-enhanced chemical vapor deposition using substrate temperatures (Tsub) of 100 and 25 °C is reported. Microcrystalline silicon (μc-Si:H) is obtained using HW with a large crystalline fraction and a crystallite size of ∼30 nm for hydrogen dilutions above 85% independently of Tsub. The deposition of μc-Si:H by rf, with a crystallite size of ∼8 nm, requires increasing the hydrogen dilution and shows decreasing crystalline fraction as Tsub is decreased. The photoconductivity, defect density, and structure factor of the amorphous silicon films (a-Si:H) are strongly improved by the use of hydrogen dilution in the Tsub range studied. a-Si:H films with a photoconductivity-to-dark conductivity ratio above 105, a deep defect density below 1017 cm−3, an Urbach energy below 60 meV and a structure factor below 0.1 were obtained for rf films down to 25 °C (at growth rates ∼0.1–0.4 Å/s) and for HW films down to 100 °C (at growth rates ∼10 Å/s), using the appropriate hydrogen dilution. In the low Tsub range studied, the growth mechanism, film properties, and the amorphous to microcrystalline silicon transition depend on the flux of atomic hydrogen available. The properties of the films are compared to those of samples produced at 175 and 250 °C in the same reactors.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.