Ammonia detection of 1-D ZnO/polypyrrole nanocomposite: Effect of CSA doping and their structural, chemical, thermal and gas sensing behavior

Abstract

Nanocomposites of polypyrrole (PPy) with varying concentration of ZnO nanorods (ZnO NRs) were synthesized using in-situ oxidative polymerization technique. The prepared nanocomposites (PPy, PPy-ZnO and CSA doped PPy-ZnO) were studied for various oxidizing and reducing gases at room temperature and found to be more selective towards ammonia gas. Various concentrations of ZnO NRs in Ppy matrix were studied and 15% was found to be optimum in terms of sensor response (66% towards 120ppm NH3). Further, with 15% doping of camphor sulphonic acid (CSA) in PPy-ZnO nanocomposite for 15% ZnO NRs in Ppy matrix, sensor response increased from 66 to 79% towards 120ppm of NH3. Structural, Optical and thermal behavior of nanocomposites were studied using powder X-ray diffraction (XRD), Fourier Transform Infra-Red (FTIR) spectroscopy, X-ray Photoelectron Spectroscopy (XPS), UV–vis (UV–vis) absorption spectroscopy, room temperature Photoluminescence (PL) Spectroscopy, Thermo-gravimetric analysis (TGA) and Field Emission Scanning Electron Microscopy (FESEM). ZnO has been completely embedded inside the polymeric chains as observed from in SEM. Meanwhile, FT-IR spectra indicate better conjugation and interaction in nanocomposites. With CSA doping interaction grows stronger due to extended delocalization over π electrons leading to higher sensor response and with response time and recovery time of 24s and 34s respectively. CSA doped PPy-ZnO (15%) nanocomposites observed to be a potential candidate for ammonia detection at lower ppm level.