Amine-functionalized MIL-101(Cr) fibers for direct air capture at cold temperatures using rapid temperature vacuum swing adsorption

Abstract

Given that most of the world shows annual temperatures lower than 25 °C and some regions exhibit a large diurnal temperature difference in a single day, it is desirable to explore the CO2 sorption behavior of materials not only at ambient (25 °C) but also at cooler, “sub-ambient” conditions (defined here as < 25 °C). These cold temperatures may offer advantages for DAC such as higher gas adsorption capacities and lower absolute humidity, reducing concomitant water adsorption. Here, amine-functionalized MIL-101(Cr) fibers are evaluated at cold temperatures using rapid temperature vacuum swing adsorption (RTVSA). MIL-101(Cr)/cellulose acetate fibers loaded with macromolecular amines are evaluated as practical gas–solid contactors. As spun MIL-101(Cr) fibers show desirable properties for use as structured contactors such as high permeance and low pressure drop. Breakthrough and RTVSA experiments are conducted in the presence of humidity at sub-ambient temperatures to understand the CO2 adsorption and desorption behavior of the sorbent/contactor under conditions approaching practical operation. With optimized amine loading, the PEI-MIL-101(Cr) fibers give CO2 capacities comparable to the powder form of the sorbent, as well as sharp breakthrough curves at fast flow rates (1.4 m/s superficial velocity) suggesting the system is not limited by additional mass transfer resistances under the tested conditions. RTVSA shows fast desorption kinetics (14.4 mmol of CO2/g of fiber/h) at moderate desorption conditions, at 0.1 bar vacuum with temperatures below 80 °C. The entire cycle during RTVSA finishes in ∼ 25 min with ∼ 76 mol% CO2 purity as the product in this initial, modestly optimized study.