Abstract
This paper proposes the use of a variable-gain amplifier instead of a hard limiter for amplitude modulation (AM) suppression with low AM-PM (phase modulation) conversion. A hard limiter shows phase shift variations through input-amplitude dependent changes in output waveform, combined with bandwidth limitations. It is shown that these can be kept small only for limiter bandwidths much larger than the input frequency. A linear amplifier with variable gain used for AM suppression does not suffer from this problem. A CMOS variable-gain amplifier with gain-insensitive phase shift has been designed for this purpose. The benefits and limitations of the technique are explored with reference to an experimental 2.5 /spl mu/m BiCMOS chip for a television IF demodulator. Experimental and simulation results indicate that the AM-PM conversion can be kept below 0.5/spl deg/ at 40 MHz over an input amplitude range of 20 dB, where typical hard limiters show 3-5/spl deg/. This is achieved with an amplifier bandwidth of 80 MHz, while a hard limiter would need a bandwidth of more than 600 MHz to obtain similar results.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
