Abstract
In this research the authors tested the performance of polymer punches, filled with short carbon fibres, produced with fused filament fabrication technology for aluminium sheet deep drawing. An experimental campaign was designed to investigate the geometry accuracy of 99th produced cup and the punches wear mechanism. Results demonstrated that polymer punches are subjected to elastic and plastic deformation that affects cup radius and depth. However, the tolerance comparison with cup produced by conventional steel tools is in a range of tenth of micron; consequently, these punches can withstand the small batch or customised production of one hundred parts.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.