All-electrochemical-prepared, efficient and robust superhydrophilic/underwater superoleophobic meshes for synchronously achieving oil-water separation and water-soluble pollutant photodegradation

Abstract

Superhydrophilic/underwater superoleophobic “water-removing” type membranes can overcome the issue of surface themselves easily fouled or even blocked by oils that seriously affects the oil-water separation capacity and limits the recycle use, and thus attract a great deal of research attention. In this work, we employed the electrochemical deposition method to fabricate Cu3(PO4)2 nanosheets (NSs) vertically grown on a copper mesh (COM) to achieve efficient oil-water separation, followed by the deposition of titanium dioxide (TiO2) nanoparticles and graphitic carbon nitride (g-C3N4) nanosheets on the surface of Cu3(PO4)2 nanosheets-wrapped mesh (Cu3(PO4)2@COM), respectively. The composited meshes of TiO2@Cu3(PO4)2@COM and g-C3N4@Cu3(PO4)2@COM not only showed the considerable superhydrophilic/underwater superoleophobic property in the application of oil-water separation, but also simultaneously exhibited the desirable photocatalytic activity for the degradation of water-soluble pollutants as the water passed through the meshes. The oil-water separation efficiency of TiO2@Cu3(PO4)2@COM and g-C3N4@Cu3(PO4)2@COM can reach as high as 97 % and 96 % that both of meshes have the water flux of various water-oil mixtures above 3250 L/m2h, along with their degradation efficiency of 79 % and 90 % for RhB pollutant under full spectrum light irradiation, respectively. In addition, the as-prepared meshes have the robust, sustainable and stable properties through ten-cycles test of oil-water separation and photocatalytic degradation without significant performance decay. Our primary results provide a potential and simple route to construct multifunctional membrane materials for synchronously achieving water purification in oily wastewater.