Abstract

The article discusses the structural features of self-fluxing coatings obtained by plasma spraying air from entering the hub ring and the gas-dynamic focusing powder. It was shown that, unlike the unilateral spot powder inlet into the plasma jet, the use of the annular input node allows to increase heating efficiency and to accelerate the particles in the plasma stream. By optical and scanning electron microscopy that most of the particles forming the coating, in the plasma jet is in a molten or plasticized condition. Transmission electron microscopy revealed that high cooling rates of such particles contribute to the formation of γ-SMC supersaturated solid solution Ni-based average grain size of 80 nm.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.