Abstract
Chip–package interaction (CPI) is becoming a critical issue for the reliability of back-end-of-line (BEOL) during or after package assembly. Complex BEOL layer stacks must have sufficient mechanical strength to survive the thermally induced stresses during processing or working lifetime. Therefore, it is necessary to assess possible failure mechanisms already at early phases of development so that the integrity of the chips can be guaranteed. This paper presents an advanced experimental stability test that combines a BABSI test (Bump Assisted BEOL Stability Indentation test) with in-situ monitoring of the induced stress during this test. A good agreement was found between the applied loads to the BEOL stack, the response of stress sensors below the bump (a Cu pillar) and finite element simulations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.