Abstract
Flow separation is mostly an undesirable phenomenon and boundary layer control is an important technique for flow separation problems on airfoils and in diffusers. Longitudinal (streamwise) vortices are produced by the interaction between jets and a freestream. This technique is known as the vortex generator jet method of separation, or stall control. The vortex generator jet method is an active control technique that provides a time-varying control action to optimize performance under a wide range of flow conditions because the strength of longitudinal vortices can be adjusted by varying the jet speed. In the present study, an active separation control system using vortex generator jets with rectangular orifices has been developed. The active separation control system can be practically applied to the flow separation control of a two-dimensional diffuser. It was confirmed that the proposed active separation control system could adaptively suppress flow separation for the flow fields caused by some changes in freestream velocity and the divergence angle of the diffuser.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.