Abstract
Aiming at the problem of waveform distortion of the secondary traveling wave obtained from the primary traveling wave signal transmitted by the voltage traveling wave sensor, an accurate detection method of voltage traveling wave based on ensemble empirical mode decomposition (EEMD) and L1 norm least squares regularization is proposed in this paper. Firstly, the forward transfer function model of the specialized voltage traveling wave sensor is established, and the inversion model is derived to analyze the phase frequency and amplitude frequency characteristics of the secondary traveling wave after transmission. EEMD is used to decompose the secondary traveling wave into the intrinsic modal function (IMF) components of different frequency bands. The L1 norm least square regularization inversion algorithm was used to invert each IMF component. Finally, the IMF' components after inversion are synthesized to obtain the primary traveling wave. Simulation and experimental results demonstrate that the proposed method is not affected by noise, mode aliasing effect and regularization parameter accuracy, and the obtained waveform has high similarity to the simulated waveform, which enables precise identification of fault traveling wave.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Electrical Power and Energy Systems
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
