Abstract
AbstractAt high current densities, gas bubble escape is the critical factor affecting the mass transport and performance of the electrolyzer. For tight assembly water electrolysis technologies, the gas diffusion layer (GDL) between the catalyst layer (CL) and the flow field plate plays a critical role in gas bubble removal. Herein, we demonstrate that the electrolyzer's mass transport and performance can be significantly improved by simply manipulating the structure of the GDL. Combined with 3D printing technology, ordered nickel GDLs with straight‐through pores and adjustable grid sizes are systematically studied. Using an in situ high‐speed camera, the gas bubble releasing size and resident time have been observed and analyzed upon the change of the GDL architecture. The results show that a suitable grid size of the GDL can significantly accelerate mass transport by reducing the gas bubble size and the bubble resident time. An adhesive force measurement has further revealed the underlying mechanism. We then proposed and fabricated a novel hierarchical GDL, reaching a current density of 2 A/cm2 at a cell voltage of 1.95 V and 80 °C, one of the highest single‐cell performances in pure‐water‐fed anion exchange membrane water electrolysis (AEMWE).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.