Abstract
Low level presence of unapproved genetically engineered (GE) materials in non-GE grains has been a challenge for grain importers and exporters and many countries also have regulatory requirements for use and cultivation of GE crops. Digital PCR has been used for absolute quantification of GE traits. The need for DNA pre-treatment for droplet digital PCR (ddPCR) has not been well assessed. The effect of non-shearing, QIAshredding and hydroshearing of genomic DNA (300 ng) on quantitative analysis of low concentrations of OXY235 canola, FP967 flax and DP305423 soybean samples was assessed using RainDance RainDrop™ Digital PCR system. 1000 ng DNA was also used for ddPCR to determine if pre-treatment is required for high DNA concentration. The measured percentage values were close to the expected 0.01, 0.1 and 1% values for non-sheared, QIAshredded and hydrosheared samples for three GE traits using 300 ng DNA. The ddPCR results were also similar to the expected 0.01, 0.1 and 1% values for non-sheared and QIAshredded samples for the three GE traits using 1000 ng DNA. The feasibility of absolute quantification of low levels of OXY235 canola, FP967 flax and DP305423 soybean samples spiked in non-GE barley and wheat samples was investigated using ddPCR. Successful quantification of OXY235 canola, FP967 flax and DP305423 soybean DNA samples spiked in barley and wheat DNA samples was achieved at 0.01, 0.1 and 1% levels. ddPCR carried out with DNA extracted from ground DP305423 soybean samples spiked in wheat and barley samples resulted in percentage values close to the expected 0.01, 0.1 and 1% values with some exceptions. The result shows the feasibility of using ddPCR for absolute quantification of low level presence of GE materials in other grain samples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.