Abrasive wear behavior of monolithic alloy, homogeneous and functionally graded aluminum (LM25/AlN and LM25/SiO2) composites

Abstract

ABSTRACTFunctionally graded metal matrix composites (MMCs) and homogenous composites (Al/AlN and Al/SiO2-10 wt%) have been fabricated through centrifugal casting and liquid metallurgy route, respectively. The properties of these composites were compared with aluminum alloy. Microstructural characteristics and hardness were studied on the surfaces of functionally graded materials (FGMs), homogenous composites, and unreinforced aluminum alloy using an optical microscope and a Vickers micro hardness tester, respectively. Tensile test was carried out on the outer and inner sections of FGMs and specimens from homogenous composites and alloy utilizing universal testing machines (UTMs). Three-body abrasive wear test was conducted for different loads and speeds to study their effect on the surfaces of composites and alloy using dry abrasion tester. Microstructural and hardness results reveal that the outer surface of aluminum nitride (AlN)-reinforced FGM has a particle-enriched region with the highest hardness. Tensile strength was found higher in both homogenous composites compared to zones of their FGMs. Abrasion wear rate was found increased with increase in load and decreased with increase in speed. The outer surface of AlN-reinforced FGM has higher wear resistance followed by the outer surface of SiO2-reinforced FGM. Scanning Electron Microscopy (SEM) analysis was performed on worn-out surfaces and observed particle-enriched outer surface of Al/AlN FGM with less abrasion.