Abstract
In this investigation, a two-phase design strategy based on the composite of mortar phase and coarse aggregate phase is proposed for designing 3D printable concrete (3DPC) with coarse aggregate. Coussot model and Krieger-Dougherty model were utilized to establish a quantitative relationship between the rheological property of 3DPC and the volume fraction of coarse aggregate, aiming to design 3DPC with coarse aggregate based on the mix proportion of printable mortar and thus facilitate the mixture design. It is found that the plastic viscosity of 3DPC with coarse aggregate is excessively high when the volume fraction of coarse aggregate reaches to a certain value, which is the main reason restricting the printability of 3DPC with coarse aggregate. The printability of 3DPC with coarse aggregate cannot be solely evaluated by yield stress, the plastic viscosity should be taken into consideration together with yield stress for evaluation as well.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.