Abstract
AbstractA two‐dimensional, non‐isothermal, two‐phase model of a polymer electrolyte fuel cell (PEFC) is presented. The model is developed for conditions where variations in the streamwise direction are negligible. In addition, experiments were conducted with a segmented cell comprised of net flow fields. The, experimentally obtained, current distributions were used to validate the PEFC model developed. The PEFC model includes species transport and the phase change of water, coupled with conservation of momentum and mass, in the porous backing of the cathode, and conservation of charge and heat throughout the fuel cell. The current density in the active layer at the cathode is modelled with an agglomerate model, and the contact resistance for heat transfer over the material boundaries is taken into account. Good agreement was obtained between the modelled and experimental polarization curves. A temperature difference of 6 °C between the bipolar plate and active layer on the cathode, and a liquid saturation of 6% at the active layer in the cathode were observed at 1 A cm–2.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.