Abstract
We describe a new method for high-frequency precision sensing. The method combines synchronous detection with chopping in a fully differential architecture that includes an instrumentation amplifier. An integrated circuit implementation of the proposed synchronous chopping demodulator front end was designed and fabricated in a 0.35-mum CMOS process technology and tested with high-frequency inductive position sensors. The measured results show that the new technique offers considerable advantages in terms of offset reduction compared to traditional techniques for these sensors, which rely on a microcontroller to measure the offset before each position measurement is taken. The measured average input-referred offset for the 20 fabricated chip samples is 87 muV at a chopping frequency of 500 kHz when the resonant target is off and synchronous demodulation and transmitter excitation are both applied at 1 MHz. The technique, in addition to improving system resolution and immunity to common-mode interference, allows these high-frequency position sensors to work with multiple targets, thus increasing speed and functionality.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Instrumentation and Measurement
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
