Abstract
We describe an application-specific integrated circuit (ASIC) front end for readout and control of planar high-frequency contactless inductive position sensors that contain transmitter and receiver coils on a fixed printed circuit board and a moving passive resonant target. Such an inductive position sensor suffers from transmitter-to-receiver signal coupling, which can result in a phase-sensitive offset; hence, an error in the position measurement occurs. For the receiver front end, we consider two analog synchronous mixer demodulators, which we call mixer-1 and mixer-2, and analyze their ability to reject phase-sensitive offsets due to transmitter signal breakthrough. The mathematical analysis is validated with measured results from the fabricated ASIC in a 0.35-mum CMOS process technology. The ASIC front end contains the transmitter driver, the two receiver mixer variants, a frequency divider/shifter, and an amplifier low-pass filter. Measurements from five ASIC samples connected to the sensor show that, with a system gain of 320, the average output offset variation with phase difference from -99 to +117 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">deg</sup> is more than 237 mV with mixer-1 compared to less than 7 mV with mixer-2.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Instrumentation and Measurement
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
