Abstract
Wood–plastic composites (WPCs) increase the range of applications of materials by creating new material solutions. As part of this research, PLA (polylactic acid)- and HDPE (high-density polyethylene)-based composites were manufactured. Softwood sawdust or conifer bark with different sizes (large and small) were used as filler. In selected cases, the addition of 3% additives, such as calcium oxide in the case of PLA or polyethylene-graft-maleic anhydride in the case of HDPE, were tested. The manufactured composites were examined for their density profile and their susceptibility to drilling, defined by the value of the axial force occurring during drilling. The obtained results revealed that the type of matrix had the greatest influence on the axial forces during drilling. Regardless of the composite formulation, composites based on PLA had 25% to 56% higher axial forces during drilling than those based on HDPE. Furthermore, increasing the proportion of lignocellulosic fillers resulted in a decrease in the value of axial forces during drilling, with PLA composites experiencing a greater decrease than HDPE composites. The type and size of the filler had a minor impact on the axial force values during drilling. The statistical analysis indicated that the additives had a greater influence on HDPE than on PLA.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.