Abstract

Co 3O 4 has shown acceptable electrochemical properties as the anode material of Li secondary batteries. In detail, its capacity reached about 700 mAh/g, twice as high as graphite, and 93.4% of initial capacity was retained after 100 cycles. EIS (electrochemical impedance spectroscopy) analyses revealed that after the 1st cycle, the insertion or extraction of Li ions in Co 3O 4 can occur homogeneously and reversibly (randless-like behavior, homogeneous mixture: Co + Li 2O (in the state of Li insertion), Co 3O 4 (in the state of Li extraction)). In fact, the coulombic efficiency of Co 3O 4 was almost 100% except for the 1st cycle. According to P. Poizot's research on several kinds of transition metal oxides, such as Co 3O 4, CoO, NiO, etc., a small Li 2O particle size and catalytic activity of the transition metal are expected to decrease the binding energy of Li 2O tremendously. As a result, Li 2O should be easy to decompose, and transition metal oxides should be able to charge or discharge reversibly by formation or decomposition of Li 2O. However, this assumption has never been confirmed by experimental results. In our results, the CV (cyclic voltammogram) of a Li 2O–Co mixture shows much larger oxidation and reduction peaks than that of Li 2O. Based on XRD analyses, oxidation and reduction in the CV of Li 2O correspond, respectively, to the decomposition and formation of Li 2O. So, it can be asserted that Co addition to Li 2O facilitates decomposition and formation processes in Li 2O and that the catalytic effect of the transition metal must be one of the main causes that make Li 2O form or decompose repeatedly.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call