Abstract
Although biodiesels have low emission profiles, the main drawback of using biodiesel in diesel engines is higher NOx. Nowadays, the electronic controlled steam injection is a promising method for NOx control. This study investigates the effects of steam injection with diesel fuel-canola oil methyl ester (COME) blends on the performance and emissions characteristics of a direct injection (DI) single cylinder diesel engine. Steam is injected into the inlet manifold during inlet period. The combustion of diesel-COME blends has been modeled using two zone combustion model. The results have been compared with each other in terms of performance and emissions. The maximum increments in engine torque and power were measured as 2.5% for 10% COME (B10) at 1200 rpm, 2.8% for 20% COME (B20) at 2200 rpm. The effects of steam injection on performance and emissions of the diesel engine running with B10 and B20 COME blends were also investigated. Satisfaction improvements have been obtained with the combination of steam injection and COME blends. The maximum torque of the engine running with B10 and 10% steam ratio combination (B10 + S10) and B20 and 10% steam ratio combinations (B20 + S10) were found as 2.4% at 1400 rpm and 0.6% at 1400 rpm, respectively. Significant reduction has been observed in NOx emission with B10-S10 combination. The reduction rate in NOx emissions were 22% with B10-S10 and 18% with B20-S10 at 1200 rpm. The study showed that steam injection is an effective tool for controlling NOx emissions without performance degradation in the diesel engines fueled with COME blends.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have