Abstract
As new and more advanced sheet metal materials are introduced to the market, more accurate techniques for determination of failure limits are needed. One area that needs attention is edge formability, where the ISO-16630 standardized Hole Expansion Test currently is used to express this through the Hole Expansion Ratio. Over the years, this standard has been criticized for producing a large scatter in repeated tests. This paper investigates a new setup for the Hole Expansion Test which introduces draw beads into the setup to ensure sufficient restraining of the specimen during the test in an effort to reduced the scatter. In total 62 tests of a DP800 steel alloy were executed, but a large scatter in the results were still seen. It was therefore concluded that a lack of restraining force in the Hole Expansion Test was not the primary cause of the reported scatter seen in other tests.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
