Abstract
This contribution deals with the study of cut surface after the abrasive water jet application on the material Maraging Steel MS-1, prepared by the 3D printing method Direct Metal Laser Sintering. The aim of the study is to point out the morphology of the cut plane under the use of various technological parameters, like feed rate of machining and abrasive mass flow at the constant cut pressure. For the track morphology monitoring after the abrasive water jet application, scanning electron microscope was used. For the identification of observed particles stabbed in the cut track, chemical composition EDX analysis was used.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
