A straight-forward fabrication of yuba films with controllable mechanical properties by oil-in-water emulsion model system rather than soymilk

Abstract

The traditional process of producing yuba films from soybeans strictly limits the development of its industrial production due to the numerous processes and intricate procedures involved. In this study, a straight-forward and effective strategy was proposed to substitute soymilk with an emulsion made from soybean protein isolate and soybean oil for the formation of yuba films. It was found that the mechanical properties of yuba films formed through this method were controlled by the concentrations of proteins and oils. As the protein concentrations increased, a higher ratio of adsorbed proteins adhered to the surface of oil droplets, which in turn facilitated the recombination of proteins and the formation of larger aggregates during heat incubation. The rheological properties and interfacial adsorption behavior suggested that larger protein aggregates exhibited a greater diffusion rate and were more prone to unfolding and re-crosslinking at the interface through heat induction, resulting in the formation of stronger protein networks. Confocal laser scanning microscope images revealed a notable increase in the density of oil distribution within the yuba films as the oil concentrations in the pre-emulsion rose. Combined with the dense protein network formed at high protein concentrations, the elongation of yuba films was significantly increased.