A Simple Method to Manufacture a Force Sensor Array Based on a Single-Material 3D-Printed Piezoresistive Foam and Metal Coating.

Abstract

Nowadays, 3D printing is becoming an increasingly common option for the manufacturing of sensors, primarily due to its capacity to produce intricate geometric shapes. However, a significant challenge persists in integrating multiple materials during printing, for various reasons. In this study, we propose a straightforward approach that combines 3D printing with metal coating to create an array of resistive force sensors from a single material. The core concept involves printing a sensing element using a conductive material and subsequently separating it into distinct parts using metal-coated lines connected to the electrical ground. This post-printing separation process involves manual intervention utilizing a stencil and metallic spray. The primary obstacle lies in establishing a sufficient contact surface between the sprayed metal and the structure, to ensure effective isolation among different zones. To address this challenge, we suggest employing a lattice structure to augment the contact surface area. Through experimental validation, we demonstrate the feasibility of fabricating two sensing elements from a single-material 3D-printed structure, with a maximum electrical isolation ratio between the sensors of above 30. These findings hold promise for the development of a new generation of low-tech 3D-printed force/displacement sensor arrays.