Abstract
ABSTRACTThis paper proposes an overcurrent protection (OCP) circuit for power MOSFETs employed in low voltage power converters. The proposed configuration requires only discrete components with a gate driver IC and uses the voltage drop across the device for overcurrent detection. It can operate independently in cycle-by-cycle shutdown and multiple cycle shutdown modes. In coordination with a micro-controller based driver IC input signal generator and controller, the proposed OCP circuit can also operate in a single cycle latch-up and hiccup OCP modes. The performance of the proposed scheme is evaluated experimentally at both, hard and soft fault conditions. By experimentation, it is shown that the proposed circuit can operate in various protection modes and capable of protecting a MOSFET in both, hard and soft fault conditions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.