Abstract
A new type of low-proflle frequency selective surface (FSS) with an overall thickness of ‚=40 and a second-order band pass frequency response is presented. The proposed FSS is composed of two metal layers, separated by a thin dielectric substrate. Each layer is a two-dimensional periodic structure with sub-wavelength periodic unit cells. By printing the same topology on each side of the substrate, a second-order frequency response is realized. To provide a physical insight into the operating mechanism, equivalent circuit networks are also investigated in each step of design procedure. Using the proposal technique, low proflle and reduced sensitivity to angle of incident wave for both TE and TM polarizations are obtained and the overall thickness of the substrate is fairly thin. FSS samples are designed, fabricated, and installed in waveguide operating at X-band and a good agreement between the simulated and measured results is achieved.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
