Abstract
The fluidized bed ironmaking technology has attracted the attention of many researchers for decades as a direct reduction ironmaking method with many advantages. This process has been applied as a pre-treatment method in many non-blast furnace ironmaking processes. However, the sticking problem hindered its development greatly. Defining the essential cause of sticking, and fundamentally solving this problem are the key steps encountered by this process. The research works related to the prevention of sticking problem during fluidized bed reduction of fine iron ore are comprehensively summarized in this article. The causes of sticking, the influencing factors of sticking and the solution of sticking are firstly discussed, followed by the analysis on the possible development direction of future fluidized bed ironmaking technology.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
