Abstract

The characteristics of traps between the Al0.25Ga0.75N barrier and the GaN channel layer in a high-electron-mobility-transistors (HEMTs) were investigated. The interface traps at the Al0.25Ga0.75N/GaN interface as well as the border traps were experimentally analyzed because the Al0.25Ga0.75N barrier layer functions as a dielectric owing to its high dielectric constant. The interface trap density Dit and border trap density Nbt were extracted from a long-channel field-effect transistor (FET), conventionally known as a FATFET structure, via frequency-dependent capacitance–voltage (C–V) and conductance–voltage (G–V) measurements. The minimum Dit value extracted by the conventional conductance method was 2.5 × 1012 cm−2·eV−1, which agreed well with the actual transistor subthreshold swing of around 142 mV·dec−1. The border trap density Nbt was also extracted from the frequency-dependent C–V characteristics using the distributed circuit model, and the extracted value was 1.5 × 1019 cm−3·eV−1. Low-frequency (1/f) noise measurement provided a clearer picture of the trapping–detrapping phenomena in the Al0.25Ga0.75N layer. The value of the border trap density extracted using the carrier-number-fluctuation (CNF) model was 1.3 × 1019 cm−3·eV−1, which is of a similar level to the extracted value from the distributed circuit model.

Highlights

  • The characteristics of traps between the ­Al0.25Ga0.75N barrier and the GaN channel layer in a highelectron-mobility-transistors (HEMTs) were investigated

  • Previous studies focused on the characterization of traps formed at the insulator/AlGaN interface in a metal–oxide–semiconductor field-effect transistor (MOSFET) structure via frequency-dependent capacitance–voltage (C–V) and conductance–voltage (G–V) ­measurements[9,10]

  • We extracted the interface trap density (Dit) between AlGaN and GaN and the deep-level/border trap density Nbt in the AlGaN barrier layer in a long-channel AlGaN/GaN HEMT fabricated on a SiC substrate

Read more

Summary

Introduction

The characteristics of traps between the ­Al0.25Ga0.75N barrier and the GaN channel layer in a highelectron-mobility-transistors (HEMTs) were investigated. We extracted the interface trap density (Dit) between AlGaN and GaN and the deep-level/border trap density Nbt in the AlGaN barrier layer in a long-channel AlGaN/GaN HEMT fabricated on a SiC substrate.

Results
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.