Abstract
The Van Atta retro-reflector can be envisioned as a self-phasing antenna array; a phase gradient, naturally induced by an external incident wave, is inverted so the device re-radiates back towards the incident direction. This Letter demonstrates how to re-direct the re-radiated beam through passive alteration of this phase gradient. For this purpose, crosspropagating isolation is required between the incident and reradiated signal paths. To this end, polarization duplexing can be used to achieve this isolation with a passive and reciprocal structure. To provide further demonstration, a 4-element redirective array is designed and fabricated to offset its re-radiated beam by -15{\deg} from incidence. Performance is then verified using fullwave electromagnetic simulation and experimental radiation pattern measurements. It is found that the -15{\deg} angular offset is effectively retained over a wide range of incidence angles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.