A parameter-free LES model for anisotropic mesh adaptivity

Abstract

Balancing accuracy and computational cost is a challenge in the modelling of turbulent flows. A widely used method for turbulence modelling is large–eddy simulation (LES). LES allows one to describe large scale flow features at a reasonable computational cost compared to the more accurate direct numerical simulation (DNS), making it a popular choice for engineering applications. One strategy to balance accuracy and cost with LES is through the use of mesh adaptivity, which allows the degrees of freedom in a problem to be reduced by changing spatial discretisation. However, mesh adaptivity can affect accuracy when using the standard Smagorinsky LES model with an implicit filter, considering that the parameter Cs is highly dependent on the filter width, which depends on mesh resolution. This work is aimed to develop an LES model that does not require any user–defined parameters and is suitable for mesh adaptivity with implicit filter. In this study we introduce a parameter–free LES model incorporating an anisotropic eddy–viscosity formulation combined with anisotropic mesh adaptivity. In our model, the parameter Cs in the eddy–viscosity formulation of the Smagorinsky model, is replaced by a function that evaluates the relative location of turbulence fluctuations in each element with respect to the turbulence spectrum inertial range. The anisotropic formulation of the eddy–viscosity allows for the application of an appropriate filter width in different directions, improving accuracy. Additionally, the mesh adaptivity algorithm assesses the local turbulence fluctuations via local Reynolds number and vortex identification criteria. This assessment leads to the refinement of regions with higher turbulence fluctuations down to the smallest scale limit in the inertial range in the corresponding direction, and also leads to the coarsening of regions without turbulence fluctuation up to largest scale limit in the inertial range. This method is tested using a flow past a sphere test case. The results are compared both qualitatively and quantitatively to results obtained with the standard Smagorinsky model, and demonstrate the better performance of our method with lower computational cost. This allows us to simulate large Reynolds number cases and compare our quantitative results to experimental results found in the literature, emphasising that our method produces good results at reasonable computational cost.