A novel thin film composite forward osmosis membrane prepared from PSf–TiO2 nanocomposite substrate for water desalination

Abstract

In this work, polysulfone (PSf)–titanium dioxide (TiO2) nanocomposite substrates were prepared by incorporating different amounts of TiO2 nanoparticles (ranging from zero to 1wt%) into PSf matrix. The nanocomposite substrates so prepared were then characterized with respect to hydrophilicity, overall porosity, surface roughness and cross-sectional morphology. It was found that both hydrophilicity and porosity of the substrate were increased upon addition of TiO2. In addition, long finger-like structures were developed by increasing the TiO2 loading, leading to water permeability enhancement. In order to fabricate thin film nanocomposite (TFN) membranes for forward osmosis (FO) application, a thin polyamide layer was formed by interfacial polymerization of 1,3-phenylendiamine and 1,3,5-benzenetricarbonyl trichloride on the top surface of PSf–TiO2 nanocomposite substrates. Under the conditions for FO performance evaluation (10mM NaCl concentration in feed solution, 0.5 and 2.0M NaCl concentration in draw solution, and both active layer facing the feed solution (AL–FS) and active layer facing the draw solution (AL–DS) orientations), the TFN membrane prepared using PSf substrate embedded with 0.5wt% TiO2 nanoparticles (denoted as TFN0.5) exhibited the most promising results by showing high water permeability and low reverse solute flux. In comparison with control TFC membrane, the water flux of TFN0.5 membrane was improved by 86–93%, depending on the membrane orientation and draw solution concentration. The increase in water permeability can be attributed to decrease in structural parameter which resulted in decreased internal concentration polarization (ICP). Although further increase in TiO2 nanoparticles loading to 0.75 and 1wt% could result in higher water permeability, their FO performances were compromised by a significant increase in reverse solute flux. Based on the results obtained in this work, it can be concluded that adding an appropriate amount of TiO2 nanoparticles into PSf substrate could potentially improve the performance of TFC membrane during FO applications.