A novel technique for decortication of the lumbar facet joints for posterolateral fusion with percutaneous exposure: A cadaveric feasibility study

Abstract

BackgroundPercutaneous approaches to the spine have been explored recently for various procedures, including transforaminal lumbar interbody fusion. It is known that facet decortication leads to higher rates of fusion, but effective percutaneous approaches have not been well documented. There are a set of instruments used in the cervical spine for percutaneous decortication, the CORUS™ Spinal System-X (DI# 00852776006508), which may be useful in this setting. Our aim was to investigate the feasibility of decorticating the lumbar facet joints with these instruments in cadavers to aid in minimally invasive lumbar fusion. MethodsWe performed percutaneous facet joint decortication at each facet joint in the lumbar spine in two adult cadavers. We tested varying degrees of laterality for entry points and angulation for access at each level to optimize the innovative procedure. ResultsWhen using the CORUS™ Spinal System-X to obtain percutaneous access for facet decortication in the lumbar spine, we successfully dissected down to the facet joint without neurovascular injury. At the L1-L2 and L2-L3 levels, access was best obtained at 4 cm from midline with an angulation of 10°. At the L3-L4 and L4-L5 level, access was best obtained at 4 cm from midline with an angulation of 20°. ConclusionsThis study demonstrates that percutaneous lumbar facet joint decortication is feasible with the CORUS™ Spinal System-X instruments, and warrants further, comparative study in the clinical setting