Abstract
AbstractModulation strategy plays a key role in the operation of modular multilevel converters (MMC). Although many studies have been carried out on its optimization in MMC, the limitations of hardware implementation are seldom considered. This paper presents a novel and easy‐to‐implement modulation strategy that simplifies both hardware design and application. From the analysis in this paper, the widely‐used modulation methods have the problems of pulse width modulation (PWM) signal feedback and complex carrier configuration in hardware implementation. By setting up a flexible insertion and removal submodule and proposing a capacitor voltage balance algorithm based on duty ratio allocation, the proposed modulation method can allow for the separate design of the Algorithm Unit and the PWM Unit in the hardware, which solves the problem of PWM feedback and reduces the hardware requirement of the trigger system. Moreover, the proposed method can broaden the selection range of processor chips. Finally, a downscaled MMC prototype is built; the proposed method is verified by both simulation and experiment.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
