A multiple-terminal gate charging model

Abstract

A gate charging model considering charging effect at all terminals of a MOSFET is reported in this letter. The model indicates two distinct charging mechanisms existing in P MOSFETs with a protecting device at their gates during plasma processing. The charging mechanism exists when antenna size at the gate is higher than that at other terminals combined. In contrast, the charging mechanism exists in the case of antenna size at the gate lower than that at other terminals combined. The normal-mode mechanism will dominate the charging event when there is no protecting device at the transistor gate or the protecting device provides very low leakage current. On the other hand, the reverse-mode mechanism becomes dominant if the protecting device provides very high leakage current. The normal-mode charging mechanism is limited by the N-well junction leakage while in the reverse-mode mechanism, it is limited by the leakage of the protecting device. The model also suggests that larger N-well junction gives rise to higher charging damage in the normal-mode mechanism while it is opposite in the reverse-mode mechanism. These were confirmed by experimental data. The model points out that a zero charging damage can be achieved at certain combinations of the gate, source, drain and N-well antenna ratio. The knowledge of these transistor terminal antenna-ratio combinations will maximize the effective usage of the charging protection devices in circuit design. The reverse-mode charging mechanism suggests that the use of a high-leakage device at the transistor gate for charging protection may cause an opposite effect when the transistor terminal antenna ratios run into a condition that triggers this mechanism. This implies that PMOS transistors with gate intentionally pinned at ground or low potential in circuits may be prone to charging damage depending on the connectivity of their source, drain, and NW.