A multi-criteria decision-making in relieving grinding process of surface of gear milling tooth based on the archimedean spiral using taguchi-ahp-topsis method

Abstract

In this study, in order to optimize the quality criteria of the machined surface based on the Archimedean spiral, the relieving grinding process (RGP) was performed to machine the material of HSS P18 in a 1Б811 machine with four input parameters including graininess of grinding wheel (G), grinding wheel hardness (Hd), velocity of grinding wheel (V), and feed rate (s) and with three quality criteria including surface roughness (Ra), hardening of surface layer (∆HRC), and hardened layer thickness (∆L). Taguchi-AHP-Topsis method was successfully applied to solve the Multi-Criteria Decision Making (MCDM) problem in this case. The optimized results of the output parameters are surface roughness of 0.21 µm, surface hardening of 1.45 HRC, and hardened layer thickness of 34.18 µm. These results were determined at the set of the input parameters includes G, V, s with their values of 120, 24 m/s, 2.08 m/min, respectively, and Hd at level 1. The optimal results were verified through the comparison between the calculated and the experimental results using this set of optimal parameters. The differences between the calculated results and the experimental results were quite small (maximum different value was 4.8 %) Thus, the results of this study can be applied to solve the multi-objective optimization problems in RGP of the GMT surface based on the Archimedean spiral