Abstract
ABSTRACTThis article reports the design of a switchable low‐noise power amplifier (LNPA) intended for an active backscatter tag used in microwave localization and positioning applications. Due to system specifications, the backscattering transponder requires an amplifier having both low‐noise and high‐output power characteristics at the same time. Low‐noise amplifier and PA design considerations are both taken into account to realize a single structure achieving the required performances. The proposed LNPA is operating in the frequency range of 4.5–5.8 GHz. It achieves a gain of 21 dB with a ripple of ±1 dB, a noise figure of less than 2.5 dB, and an output compression point at −1 dB of 11 dBm over the operational bandwidth. This structure can be switched on and off by a control signal to modulate the tag radar cross section and enable distance measurement. A packaged prototype of the LNPA was fabricated and measured. © 2014 Wiley Periodicals, Inc. Microwave Opt Technol Lett 56:1251–1255, 2014
Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
