Abstract
The paper focuses on the hydromechanical behaviour of an unsaturated compacted clayey silt, accounting for fabric changes induced by drying–wetting cycles occurring at low stress levels. The response along isotropic compression and triaxial compression (shear) at constant water content was investigated by laboratory tests on both as-compacted and dried–wetted samples. Compaction induces a microstructural porosity pertinent to clay peds and a macrostructural porosity external to the peds. Drying–wetting cycles decrease the microporosity and increase the macroporosity, which reduces the water retention capacity, increases the compressibility, and promotes higher peak strengths with more brittle behaviour during triaxial compression. A coupled double-porosity elastic–plastic model was formulated to simulate the experimental results. A nonassociated flow rule was defined for the macrostructure, modifying a stress–dilatancy relationship for saturated granular soils to account for the increase in dilatancy with suction observed in the experiments. The average skeleton stress and suction were adopted as stress variables. As correctly predicted by the model, the shear strength at critical state is not significantly influenced by the degree of saturation or by the hydraulic history. On the contrary, the higher peak strength, brittleness, and dilatancy of the dried–wetted samples are mostly explained by their reduced water-retention capacity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.