Abstract

This paper presents a non-isolated DC–DC boost topology with a high-voltage-gain ratio for renewable energy applications. The presented converter is suitable for converting the voltage from low-voltage sources, such as photovoltaic panels, to higher voltage levels. The proposed converter consists of a multiphase boost stage with an interleaving switching technique and a voltage multiplier cell to provide a voltage level at a reduced duty cycle. The interleaved boost stage consists of two legs and can be either fed from single or multiple voltage sources with the ability to control each source separately. The voltage multiplier cell can increase the voltage level by charging and discharging the capacitors. Several advantages are associated with the converter, such as reduced voltage stress on semiconductor elements and a scalable structure, where the number of voltage multiplier cells can be increased. The inductors in the interleaved boost stage share the input current equally, which reduces the conduction loss in the inductors. The input and the output of the converter share the same ground, and all active switches are low-side, which means no feedback or signal isolation is required. The theory of operation and steady-state analysis of the converter operating in the continuous conduction mode is presented. Components selections and efficiency analysis are presented and validated by comparative analysis and simulation results. A 0.195 kW experimental prototype was designed and implemented to convert the voltage from 20 V input source to 400 V output load, at 50 kHz. The test results show a high-performance of the converter as the maximum efficiency point is above 97%.

Highlights

  • The number of renewable energy sources (RES) installations has been increasing since the end of the 20th century

  • Several high-voltage gain DC–DC step-up converters for renewable energy applications can be found in the literature [26,27,28,29,30,31,32]

  • The proposed converter has higher voltage gain compared to the conventional boost and the interleaved boost converters and lower voltage stress across elements

Read more

Summary

Introduction

The number of renewable energy sources (RES) installations has been increasing since the end of the 20th century. Cascading multiple boost converters allows operation at low duty cycles and enhances the overall voltage gain [13,14] Such an approach’s efficiency is lower because the power is processed multiple times, and the output diode is required to block the high output voltage. Increasing the number of stages limits the duty cycle’s operation to a narrow range, making the converter not suitable for applications such as tracking control and load matching Another approach used to increase the voltage gain is by employing a coupled inductor or transformer, which can be utilized to provide isolation [17,18,19].

Principle of Operation and Derivation of Steady-State Equations
Mode 1
Mode 2
Mode 3
Steady-State Static Voltage Gain
Inductor Selection
MOSFET Selection
Diode Selection
Capacitors Selection
Efficiency Analysis
Comparative Analysis
Simulation and Experimental Results
Findings
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call