A green zwitterionic bi-continuous membranes prepared by dual-bath procedure for mitigating biofouling during bacterial removal from water

Abstract

This work explores the possibility of forming green microfiltration antifouling membranes based on polyvinylidene fluoride (PVDF) and a zwitterionic copolymer derivative of sulfobetaine methacrylate (SBMA), utilizing gamma-valerolactone (GVL) as the solvent and a mixture of ethanol and water as non-solvents. Efforts were initially focused on adjusting the immersion time of the matrix polymer in alcohol alone to obtain a porous structure, and 15 s were sufficient to achieve a symmetric, open porous morphology. Next, the polymer/copolymer/solvent blend was characterized. While it did not show the characteristics of a fully miscible system, DLS and visual observations revealed the obtaining of a homogeneous (relatively narrow particle size) and transparent to translucent system. Thus, membranes could be cast, and were shown to be stable. The addition of the copolymer maintained the physical characteristics of microfiltration membranes, but an FT-IR analysis revealed its effect on the dominant crystalline polymorph (switching from β to α). The membrane wettability was enhanced in an important extent with a dynamic water contact angle (WCA) gradually falling to < 40° (while the virgin membrane's WCA remained about 138° all test long), and a hydration capacity reaching about 530 mg/cm3 against <10 mg/cm3 for the virgin membrane. It reflected on the antifouling abilities of the membranes as tested using bovine serum albumin, fibrinogen, Escherichia coli, and Stenotrophomonas maltophilia, with relative decreases in adsorption during static tests measured to be 95 %, 70 %, 91 % and 98 %, respectively. Finally, compared to the virgin membrane, the modified membrane featured improved flux recovery (32 % vs. 11 %), significantly higher rejection (98.9 % vs. 89.1 %) and lower irreversible fouling tendency (68 % vs. 89 %) during cyclic water/bacterial solution filtration in dead-end mode, making it potentially suitable for addressing bacterial pollution in wastewater.