Abstract
Lead-free perovskite solar cells (PSCs) have attracted interest among scientists searching for eco-friendly energy harvesting devices. Herein, the effects of ozone exposure on poly(3,4-ethylenedioxythiophene) polystyrene sulfonate (PEDOT:PSS) in lead-free tin halide PSCs as a facile and low-cost process for improving device performance are analyzed. Two types of tin-based PSCs and one typical lead-based PSC were fabricated. The ozone exposure on PEDOT:PSS increases the short-circuit current density (JSC) and the fill factor (FF) of PSCs in all cases with perovskite grain enlargement and hole-mobility enhancement of the devices, respectively. For open-circuit voltage (VOC), the outcome depends on the band gap and the energy levels of the perovskite films. While ozone exposure treatment is favorable for PEA0.15FA0.85SnI3-based tin PSCs, VOC decreases with ozone exposure in the case of Ge:EDA0.01FA0.98SnI3-based tin PSCs because of a misalignment of the energy levels. Regardless, the efficiency of PEA0.15FA0.85SnI3-based tin PSCs increases from 8.7 to 10.1% when measured inside a glovebox upon ozone exposure of PEDOT:PSS. The efficiency of Ge:EDA0.01FA0.98SnI3-based tin PSCs increases from 6.8 to 8.1%, and the devices retain an efficiency of 5.0% even after 50 days in air.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
