A digital light processing 3D-printed artificial skin model and full-thickness wound models using silk fibroin bioink.

Abstract

A three-dimensional (3D) artificial skin model offers diverse platforms for skin transplantation, disease mechanisms, and biomaterial testing for skin tissue. However, implementing physiological complexes such as the neurovascular system with living cells in this stratified structure is extremely difficult. In this study, full-thickness skin models were fabricated from methacrylated silk fibroin (Silk-GMA) and gelatin (Gel-GMA) seeded with keratinocytes, fibroblasts, and vascular endothelial cells representing the epidermis and dermis layers through a digital light processing (DLP) 3D printer. Printability, mechanical properties, and cell viability of the skin hydrogels fabricated with different concentrations of Silk-GMA and Gel-GMA were analyzed to find the optimal concentrations for the 3D printing of the artificial skin model. After the skin model was DLP-3D printed using Gel-GMA 15% + Silk-GMA 5% bioink, cultured, and air-lifted for four weeks, well-proliferated keratinocytes and fibroblasts were observed in histological analysis, and increased expressions of Cytokeratin 13, Phalloidin, and CD31 were noted in immunofluorescence staining. Furthermore, full-thickness skin wound models were 3D-printed to evaluate the wound-healing capabilities of the skin hydrogel. When the epidermal growth factor (EGF) was applied, enhanced wound healing in the epidermis and dermis layer with the proliferation of keratinocytes and fibroblasts was observed. Also, the semi-quantitative reverse transcription-polymerase chain reaction revealed increased expression of Cytokeratin 13, fibroblast growth factor, and CD31 in the EGF-treated group relative to the control group. The DLP 3D-printed artificial skin model was mechanically stable and biocompatible for more than four weeks, demonstrating the potential for application in skin tissue engineering. STATEMENT OF SIGNIFICANCE: A full-thickness artificial skin model was 3D-printed in this study with a digital light processing technique using silk fibroin and gelatin, which mimics the structural and cellular compositions of the human skin. The 3D-printed skin hydrogel ensured the viability of the cells in the skin layers that proliferated well after air-lifting cultivation, shown in the histological analysis and immunofluorescence stainings. Furthermore, full-thickness skin wound models were 3D-printed to evaluate the wound healing capabilities of the skin hydrogel, which demonstrated enhanced wound healing in the epidermis and dermis layer with the application of epidermal growth factor on the wound compared to the control. The bioengineered hydrogel expands the applicability of artificial skin models for skin substitutes, wound models, and drug testing.